Skip to main content

Flow cytometric analysis of circulating platelet-monocyte aggregates in whole blood: methodological considerations.

Harding SA, Din JN, Sarma J, Jessop A, Weatherall M, Fox KA, Newby DE

Publication: Thromb Haemost (2007) • Vol 98 • Page 451-6PMID: 17721630View on PubMed

Purpose

The purpose of this paper was to determine the effects of type of anticoagulant, collection method, processing delays, hemolysis, and refrigerated storage of fixed specimens on platelet-monocyte aggregate evaluation by flow cytometry.

Conclusion

Significantly different percentages of platelet-monocyte aggregates were observed between blood specimens incubated for 5 minutes in the different anticoagulants. The highest percentage of aggregates was measured in lithium heparin blood, followed by D-phenylalanyl-L-prolyl-L-arginine chloromethyl ketone (PPACK), then citrated blood, and finally EDTA blood. Specimens collected via intravenous catheter rather than venipuncture had significantly higher baseline levels of platelet-monocyte aggregation, and platelet-monocyte aggregation increased with sequential collection via intravenous catheter over time, but it did not increase with multiple venipunctures. Room temperature processing delays between 10 and 60 minutes caused platelet-monocyte aggregate percentages to increase for both PPACK and citrated blood (other anticoagulants not tested). Erythrocyte lysis by the addition of FACS lyse solution had no effect on platelet-monocyte aggregation. Storing fixed specimens at 4 degrees C for up to 24 h before analysis had no effects on the percentage of platelet-monocyte aggregates measured.

Studies (1)

Purpose

The purpose of this study was to determine the effects of type of anticoagulant, collection method, processing delays, hemolysis, and refrigerated storage of fixed specimens on platelet-monocyte aggregate evaluation by flow cytometry. All experiments were performed with blood from 8 healthy volunteers.

Summary of Findings

Significantly different percentages of platelet-monocyte aggregates were observed between blood specimens incubated for 5 minutes in the different anticoagulants. The highest percentage of aggregates was measured in lithium heparin blood, followed by PPACK, then citrated blood, and finally EDTA blood. Specimens collected via intravenous catheter rather than venipuncture had significantly higher baseline levels of platelet-monocyte aggregation, and platelet-monocyte aggregation increased with sequential collection by intravenous catheter over time, but it did not increase with multiple venipunctures. Room temperature processing delays between 10 and 60 minutes caused platelet-monocyte aggregate percentages to increase for both PPACK and citrated blood (other anticoagulants not tested). Erythrocyte lysis by the addition of FACS lyse solution had no effect on platelet-monocyte aggregation. Storing fixed specimens at 4 degrees C for up to 24 h before analysis had no effects on the percentage of platelet-monocyte aggregates measured.

  • Biospecimens

    FluidBlood
  • Preservation Types

    None (Fresh)Other Preservative
  • Diagnoses

    Normal
  • Platforms

    Cell count/volumeFlow cytometry
  • Pre-analytical Factors

    ClassificationPre-Analytical FactorValue(s)
    Biospecimen AcquisitionAnticoagulant
    EDTA
    Lithium heparin
    PPACK
    Sodium citrate
    Biospecimen AcquisitionMethod of fluid acquisition
    IV catheter
    Venipuncture
    Biospecimen AcquisitionTime of biospecimen collection
    30 min
    50 min
    85 min
    Baseline
    Biospecimen Aliquots and ComponentsAliquot sequential collection
    1st collection
    2nd collection
    3rd collection
    4th collection
    Biospecimen Aliquots and ComponentsHemolysis
    Chemically-induced
    Not induced
    Biospecimen PreservationType of fixation/preservation
    None (fresh)
    Refrigeration
    StorageStorage duration
    0 h
    12 h
    24 h
    4 h
    8 h
    StorageTime at room temperature
    0 min
    10 min
    20 min
    30 min
    60 min