Skip to main content

Serum peptide profiling by magnetic particle-assisted, automated sample processing and MALDI-TOF mass spectrometry.

Villanueva J, Philip J, Entenberg D, Chaparro CA, Tanwar MK, Holland EC, Tempst P

Publication: Anal Chem (2004) • Vol 76 • Page 1560-70PMID: 15018552View on PubMed

Purpose

The purpose of this paper was to determine the effects of specimen preparation method and MALDI-TOF protocols on serum peptide profiles.

Conclusion

Using magnetic beads derivatized with a carbon chain length of 8 (C8), 50 ug beads/uL serum, elution with 50% acetonitrile (MeCN) at 1 uL MeCN per 500 ug beads, alpha-cyano-4-hydroxy-trans-cinnamic acid (HCCA) as the matrix, 40% MeCN/50% methanol/10% water as the solvent, and 20-30 higher power laser shots prior to data acquisition in the linear mode resulted in a high number of peaks. This number of peaks could be slightly increased by applying the serum to a strong cation exchange column (SCAX) and eluting at increasing concentrations of sodium chloride before application to C8 beads and by a two-step MeCN elution. Similar spectra were observed when specimen handling was manual or automated. Use of the protocol outlined above allowed for identification of peptides differentially expressed between healthy controls and glioblastoma patients.

Studies (1)

Purpose

The purpose of this study was to determine the effects of specimen preparation method and MALDI-TOF protocols on serum peptide profiles. Serum was stored at -80 degrees C until analysis.

Summary of Findings

Using only magnetic beads derivatized with C8 resulted in the largest number of MALDI-TOF peaks both in the 0.8-4Kda and 4-15 Kda range, and the authors report using beads with a porous surface improved binding capacity. The maximum number of peaks attainable was similar for all serum amounts, and a ratio of 50 ug beads/uL serum resulted in the highest number of MALDI-TOF peaks. More peaks resulted from elution with 50% MeCN at 1 uL MeCN per 500 ug beads than 20% or 70% MeCN, methanol, 2-propanol, or ethanol of from more or less MeCN, but two-step elution (20% MeCN, then 70% MeCN) increased the number of peaks by 8%. Pretreatment of serum with urea, urea/dithiothreitol (DTT), ethanol precipitation, cibachron blue, or ultrafiltration, with or without urea, decreased the number of MALDI-TOF peaks, and prewashing the serum tubes with n-octylglucoside did not increase the number of peptide peaks. Applying the serum to SCAX and eluting with increasing concentrations of sodium chloride applied to C8 beads increased the number of peaks by 30. Using HCCA as the MALDI-TOF matrix and 40% MeCN/50% methanol/10% water as the solvent resulted in more peaks than using 2,5-dihydroxybenzoic acid (DHB) or sinapic acid as the matrix and other concentrations of MeCN, methanol, 2-propanol, water and trifluoroacetic acid (TFA) as the solvent. Using 20-30 higher power laser shots prior to 100 laser shots at lower power increased the number of peaks compared to acquiring data with 100 lower power laser shots. Using the linear mode during acquisition rather than reflectron increased the number of peaks by a factor of 4. Similar spectra were observed when specimen handling was manual or automated. Use of the automated protocol allowed for identification of peptides differentially expressed between healthy controls and glioblastoma patients.

  • Biospecimens

    FluidSerum
    FluidBlood
  • Preservation Types

    Frozen
  • Diagnoses

    Normal
    NeoplasticSarcoma
  • Platforms

    PeptideMALDI-TOF MS
    ProteinMALDI-TOF MS
  • Pre-analytical Factors

    ClassificationPre-Analytical FactorValue(s)
    PreaquisitionDiagnosis/ patient condition
    Glioblastoma
    Normal volunteer
    Biospecimen AcquisitionType of collection container/solution
    Serum tube treated with n-octylglucoside
    Untreated serum tube
    Biospecimen Aliquots and ComponentsAliquot size/volume
    100 ul serum
    20 ul serum
    5 ul serum
    50 ul serum
    Biospecimen Aliquots and ComponentsFiltration
    Centricon 30 ultrafiltration after incubation with urea
    No filtration
    Analyte Extraction and PurificationAnalyte purification
    1-step
    2-propanol
    2-step
    20%
    50%
    70%
    Acetonitrile
    Automated preparation
    C1 magnetic beads
    C1 or C2 and then C8 magnetic beads
    C18 magnetic beads
    C2 magnetic beads
    C3 and C8 magnetic beads
    C3 magnetic beads
    C8 and C18 magnetic beads
    C8 magnetic beads
    Ethanol
    Methanol
    Various concetrations beads
    MALDI-TOF MS SpecificDetection method
    20-30 higher power laser shots prior 100 standard power shots
    Standard laser power for all shots
    MALDI-TOF MS SpecificReaction solution
    Various concentrations of MeCN, methanol, 2-propanol, water and TFA
    MALDI-TOF MS SpecificTechnology platform
    Linear mode
    Reflectron
    MALDI-TOF MS SpecificTemplate modification
    Cibachron blue
    Ethanol precipitation
    None
    Ultrafiltration
    Urea
    Urea/DTT