Skip to main content

Effect of centrifugation on the storage properties of platelets.

Solberg C, Moen P, Little C

Publication: Vox Sang (1988) • Vol 55 • Page 97-103PMID: 3188441View on PubMed

Purpose

The purpose of this paper was to determine the effects of centrifugation speed and storage container on the stability of platelet properties.

Conclusion

Before storage, the platelet concentrations obtained by the three different centrifugation methods were similar. However, after storage, the platelet concentrations and partial pressure carbon dioxide (PCO2) were lower and the pH, lactate dehydrogenase discharge, and partial pressure oxygen (PO2) were higher when platelet concentrates (PC) were produced by centrifugation at 2200 x g for 4 min 15 sec followed by 5190 x g for 6 min (method 1) or 1100 x g for 6 min followed by 4800 x g for 6 min (method 2) than when centrifuged at 3270 x g for 2 min 15 sec followed by 3540 x g for 5 min (method 3). The authors conclude that centrifugation method 3 and storage in Fenwal PL 732 produced the PC with the best storage properties.

Studies (1)

Purpose

The purpose of this study was to determine the effects of centrifugation speed and storage container on the stability of platelet properties. Platelet concentrates were obtained from fresh citrate-phosphate-dextrose blood using three centrifugation protocols and stored in either Fenwal PL 1240 or 732 bags with 5 and 7 day expiration times, respectively.

Summary of Findings

Before storage, the platelet concentrations obtained by the three different centrifugation parameters were similar. After storage, the PC decreased more in platelets prepared by centrifugation at 2200 x g for 4 min 15 sec followed by 5190 x g for 6 min (method 1) or 1100 x g for 6 min followed by 4800 x g for 6 min (method 2) than by centrifugation at 3270 x g for 2 min 15 sec followed by 3540 x g for 5 min (method 3). The pH increased with storage in 4 of 9 and 5 of 11 PC prepared by methods 1 and 2, respectively, but pH decreased with storage in all 30 specimens prepared by method 3 with the largest effect noted when PC were stored in PL 1240 bags (which expire at 5 days). The pH change with storage was mostly accounted for by the change in platelet concentrations in specimens prepared by methods 1 and 2, but not method 3. In specimens stored for just 1 day, the PO2 was significantly lower in PC prepared by method 3 than by method 1 or 2. While the PO2 increased and the PCO2 decreased with storage in all specimens, the increase with storage was larger in specimens obtained by method 1 or 2 than by method 3. Finally, the lactate dehydrogenase discharge and number of small particles was smaller in PC prepared by method 3 than by method 1 or 2. The authors conclude that method 3 produces the PC with the best storage properties.

  • Biospecimens

    FluidBlood
  • Preservation Types

    None (Fresh)
  • Diagnoses

    Not specified
  • Platforms

    Small moleculepH
    GasClinical chemistry/auto analyzer
    ProteinClinical chemistry/auto analyzer
    Cell count/volumeHematology/ auto analyzer
  • Pre-analytical Factors

    ClassificationPre-Analytical FactorValue(s)
    Biospecimen Aliquots and ComponentsCentrifugation
    Multiple durations compared
    Multiple speeds compared
    StorageTime at room temperature
    1 day
    6 days
    StorageType of storage container
    Fenwal PL 1240
    Fenwal PL 732