The purpose of this paper was to determine the effects of specimen type, anticoagulant choice, delay to centrifugation, centrifugation speed, storage, freeze-thaw cycling, and blood components on the measurement of soluble CD40 ligand (sCD40L).
Influence of pre-analytical and analytical factors on soluble CD40L measurements.
Varo N, Nuzzo R, Natal C, Libby P, Schönbeck U
Purpose
Conclusion
sCD40L levels were higher in serum than in plasma, but were unaffected by the type of anticoagulant used. Levels of sCD40L increased in serum when blood was stored at room temperature for 2 h or 6 h prior to centrifugation rather than for 30 min. Increasing the centrifugation speed led to a gradual decrease in sCD40L levels measured in plasma as the platelet and leukocyte levels decreased. Up to 3 freeze-thaw cycles did not affect sCD40L levels in plasma with a low platelet count but increased sCD40L in platelet rich plasma. After centrifugation, storage of serum at 4 degrees C for 48 h did not affect sCD40L levels, but when serum was stored at room temperature, sCD40L levels declined with storage. Bilirubin and hemoglobin interfered with the measurement of sCD40L at all levels, but cholesterol and triglycerides only affected sCD40L measurement when present at pathological levels. Endogenous sCD40L was not detected in urine specimens, but recovery of spiked sCD40L was highest in urine specimens with a pH of 5-8.
Studies (2)
Purpose
The purpose of this study was to determine the effects of anticoagulant choice, delay to centrifugation, centrifugation speed (200 x g, 400 x g, 1000 x g, 2000 x g, 13000 x g), storage, freeze-thaw cycling, and blood components on the measurement of sCD40L.
Summary of Findings
sCD40L levels were higher in serum than in plasma (p=0.001) and were not correlated with one another. There were no significant differences in sCD40L levels when heparin, EDTA, or citrate was used for anticoagulation. When blood was stored at room temperature for 2 h or 6 h prior to centrifugation, levels of sCD40L in serum were 15 and 22% higher, respectively than when blood was stored for 30 min. Increasing the centrifugation speed led to a gradual decrease in sCD40L levels measured in plasma as the platelet and leukocyte levels decreased, but no additional effect was noted at centrifugation speeds greater than 1000 g. Up to 3 freeze-thaw cycles did not affect sCD40L levels in plasma with a low platelet count but increased sCD40L in platelet rich plasma. After centrifugation, storage of serum at 4 degrees C for 48 h did not affect sCD40L levels, but when serum was stored at room temperature, sCD40L levels declined with storage. Bilirubin and hemoglobin interfered with the measurement of sCD40L at all levels. While normal physiological concentrations of cholesterol and triglycerides (<250 mg/dL and <200 mg/dL respectively) did not affect measurement of sCD40L, pathological levels of triglycerides and cholesterol led to decreases in measured sCD40L levels. sCD40L levels were higher in plasma from diabetic patients than healthy controls.
Biospecimens
FluidPlasmaFluidSerumFluidBloodPreservation Types
None (Fresh)Diagnoses
Diabetes Type 2Diabetes Type 1NormalPlatforms
ProteinELISAPre-analytical Factors
Classification Pre-Analytical Factor Value(s) Preaquisition Biomarker level Bilirubin (50-200 mg/mL)Cholesterol (150-300 mg/dL)Hemoglobin (12-36 mg/mL)High sCD40LLow sCD40LTriglycerides (50-400 mg/dL)Preaquisition Diagnosis/ patient condition DiabetesNormalBiospecimen Acquisition Anticoagulant CitrateEDTAHeparinNoneBiospecimen Aliquots and Components Blood and blood products Platelet-poor plasmaPlatelet-rich plasmaSerumBiospecimen Aliquots and Components Centrifugation Centrifugation delays investigatedMultiple speeds comparedStorage Freeze/thaw cycling 0 cycles1 cycle2 cycles3 cyclesStorage Storage duration 0 h24 h48 h6 hStorage Storage temperature 4 degrees CRoom temperatureStorage Time at room temperature 2 h30 min6 h
Purpose
Summary of Findings
Biospecimens
FluidUrinePreservation Types
None (Fresh)Diagnoses
Diabetes Type 1Diabetes Type 2NormalPlatforms
ProteinELISAPre-analytical Factors
Classification Pre-Analytical Factor Value(s) Biospecimen Aliquots and Components pH 23456789