Skip to main content

A well-based reverse-phase protein array applicable to extracts from formalin-fixed paraffin-embedded tissue.

Chung JY, Lee SJ, Kris Y, Braunschweig T, Traicoff JL, Hewitt SM

Publication: Proteomics Clin Appl (2008) • Vol 2 • Page 1539-47PMID: 21136801View on PubMed

Purpose

The purpose of this paper was to determine the optimal method of protein extraction from formalin-fixed paraffin-embedded (FFPE) tissue for the recovery of full-length immunoreactive proteins measureable by a novel well-based reverse phase protein array (WBRPPA).

Conclusion

The largest amount of quality immunoreactive protein was recovered from FFPE tissue when extraction included incubation in antigen retrieval lysis buffer with pH 9.9, and the addition of 1% SDS and 10% glycerol. Incubation at 65 degrees C for 3 h led to superior immunoreactive protein recovery compared to lower temperatures. Antigen retrieval (AR) pretreatment in a pressure cooker at a temperature of 115 degrees C for 15 minutes was superior in terms of protein recovery to no AR, or AR at other temperatures or lengths of time. The authors state that with these extraction parameters, 90% of the protein extracted from an equal volume of fresh tissue was able to be recovered from FFPE tissue. WBRPPA data generated from protein extracted from LCM FFPE tissue showed high correlation with Western blot data and greater sensitivity. Storage of vacuum-sealed plates at room temperature for up to 56 d after protein coating resulted in minimal changes to WBRPPA profiles for prostate specific antigen (PSA).

Studies (1)

Purpose

The purpose of this study was to determine the optimal method of protein extraction from FFPE tissue for the recovery of full-length immunoreactive proteins measureable by WBRPPA. FFPE specimens were stored for more than 7 y at room temperature prior to this study.

Summary of Findings

The optimum methods for protein extraction included incubation in AR lysis buffer with pH 9.9, as opposed to the same buffer at a pH of 6.0, RIPA, or T-PER buffers. Inclusion of 1% SDS gave higher protein yields compared to the inclusion of 2% SDS, several other detergents, or a combination of SDS and triton X-100 to the lysis buffer. The addition of 10% glycerol to the extraction buffer was also beneficial, but deparaffinization made no difference in protein yield. Incubation in lysis buffer at a higher temperature (65 degrees C) as opposed to 4, 25, or 37 degrees C, resulted in a broader spectrum of proteins recovered. AR pretreatment was superior to no AR, and a pressure cooker temperature of 115 degrees C was superior to 100 or 124 degrees C in terms of protein recovery. While longer AR times resulted in increased protein yields, protein quality declined when AR was for more than 30 min in a pressure cooker, as determined by Western blotting using PSA, phospho-protein kinase B (pAKT), Beta-tubulin, alpha-methylacyl-CoA (AMACR), and glyceraldehyde-3-phosphate dehydrogenase (GAPDH) antibodies. The optimum AR time for recovery of intact protein was determined to be 15 min. The authors state that with these extraction parameters, 90% of the protein extracted from an equal volume of fresh tissue was able to be recovered from FFPE tissue. WBRPPA data generated from protein extracted from LCM FFPE tissue showed high correlation with Western blot data and showed greater sensitivity. Storage of vacuum-sealed plates at room temperature for up to 56 d after protein coating resulted in minimal changes to WBRPPA profiles for PSA.
  • Biospecimens

    TissueProstate
  • Preservation Types

    Formalin
  • Diagnoses

    Not specified
  • Platforms

    ProteinColorimetric assay
    Protein1D/2D gels
    ProteinWestern blot
    ProteinReverse phase protein microarray
  • Pre-analytical Factors

    ClassificationPre-Analytical FactorValue(s)
    StorageTime at room temperature
    1 d
    14 d
    28 d
    3 d
    56 d
    7 d
    Analyte Extraction and PurificationAnalyte isolation method
    AR buffer pH 6.0
    AR buffer pH 9.9
    RIPA lysis buffer
    T-PER lysis buffer
    Analyte Extraction and PurificationAntigen retrieval
    None
    Pressure cooker 10 min
    Pressure cooker 15 min
    Pressure cooker 30 min
    Pressure cooker 5 min
    Pressure cooker 60 min
    Analyte Extraction and PurificationDeparaffinization
    None
    Yes
    Analyte Extraction and PurificationIncubation duration/condition
    3 h at 25 degrees C
    3 h at 37 degrees C
    3 h at 4 degrees C
    3 h at 65 degrees C
    Analyte Extraction and PurificationProtein solubilization
    1% SDS
    2% SDS
    Addition of 10% glycerol
    CHAPS
    CYMAL-7
    Combinational detergents with SDS and triton X-100
    N-dentyl-Beta-D maloside detergent
    NP-40
    No glycerol
    Octyl-D glucopyranoside detergent
    Triton X-100
    Analyte Extraction and PurificationTemperature of heat-induced retrieval
    100 degrees C
    115 degrees C
    124 degrees C
    Western blot SpecificTargeted peptide/protein
    AMACR
    Beta-tubulin
    GAPDH
    PSA
    pAKT
    Reverse phase protein microarray SpecificTechnology platform
    Western blot