Sampling and storing of blood for determination of acid-base status
Siggaard-Andersen O
Purpose
Conclusion
Studies (2)
Purpose
The purpose of this study was to determine the effects of dilution, anticoagulant, storage and blood components on pH, pCO2, bicarbonate, and base excess levels in blood.
Summary of Findings
Dilution of whole blood or plasma by 12-13% with saline led to an increase in pH and decreases in pCO2, bicarbonate and base excess. With each 1 mg/mL of sodium heparin added to blood, there was a decrease in pH of 0.003, a 0.1 mm mercury rise in pCO2 and a 0.2 miliequivalent/L decrease in base excess, but the use of sodium heparin as an anticoagulant had no effects on these analytes in lipemic blood. When blood from healthy individuals was stored anaerobically at 38 degrees C, room temperature, or 0-4 degrees C, pH declined by 0.066, 0.026 and 0.006 per hour, respectively, for the first 3 h of storage. After the first 3 h, the rates of decline in pH, pC02 and base excess decreased, but levels continued to decline. For these parameters, the rates of decline in the first 3 h were independent of hemoglobin concentration, but were increased with high leukocyte concentrations. There were no differences in the rates of decline in pH with storage between heparinized and unheparinized or capillary and venous blood.
Biospecimens
FluidBloodFluidPlasmaPreservation Types
None (Fresh)Diagnoses
Not specifiedNormalOther diagnosesPlatforms
Electrolyte/MetalFlame emission photometryGasClinical chemistry/auto analyzerSmall moleculepHSmall moleculeClinical chemistry/auto analyzerProteinSpectrophotometryPre-analytical Factors
Classification Pre-Analytical Factor Value(s) Preaquisition Diagnosis/ patient condition LipemicBiospecimen Acquisition Anatomical location of blood draw CapillaryVeinBiospecimen Acquisition Anticoagulant Multiple concentrations evaluatedNoneSodium heparinBiospecimen Aliquots and Components Biospecimen components Diluted with salineHemolyzed bloodNo dilutionPlasma containing 64,000 leukocytes and 1 g hemoglobin/LBiospecimen Aliquots and Components Blood and blood products PlasmaWhole bloodStorage Storage duration 0 min1 h12 h2 h24 h3 h30 min4 h48 h5 h6 hStorage Storage temperature 0-4 degrees C20-24 degrees C38 degrees C
Purpose
The purpose of this study was to determine the effects of use of sodium fluoride as an anticoagulant, storage and blood components on pH, pCO2, bicarbonate, base excess, and glucose levels in blood.
Summary of Findings
The addition of 0.25 mg/mL or less sodium fluoride to blood led to a decrease in pH with increasing storage time at 38 degrees C, but when higher sodium fluoride concentrations were used, the pH increased with storage time at 38 degrees C. The maximum increase in pH was observed with 1 mg/mL sodium fluoride. The rate of increase in pH with increasing storage time at 38 degrees C was slower when 2 mg/mL sodium fluoride was added than when 1 mg/mL sodium fluoride was added. During the first 30 min-1 h of storage at 38 degrees C, the pH and base excess decreased and the pCO2 increased in blood containing 1 mg/mL of sodium fluoride. Between 1 and 3 h of storage at 38 degrees C, the pH, pCO2 and base excess of blood containing 1 mg/mL sodium fluoride all increased, but after 3 h, base excess and pH began to decline while pCO2 continued to increase and did not begin to decline until 6 h of storage. Storage of sodium fluoride blood at 22 degrees C, led to similar changes in pH, base excess and PCO2 compared to blood stored at 38 degrees C, but with a 1-1.5 h delay. When 1 mg/mL sodium fluoride was added to leukocytes in plasma or saponin hemolyzed blood, there was a decline in pH during the first 30 min of storage at 38 degrees C. In blood stored with 1 mg/mL sodium fluoride, the glucose level did not change with storage for at least 24 h.
Biospecimens
FluidBloodFluidPlasmaPreservation Types
None (Fresh)Diagnoses
NormalNot specifiedPlatforms
CarbohydrateClinical chemistry/auto analyzerElectrolyte/MetalFlame emission photometryGasClinical chemistry/auto analyzerProteinSpectrophotometrySmall moleculepHSmall moleculeClinical chemistry/auto analyzerPre-analytical Factors
Classification Pre-Analytical Factor Value(s) Biospecimen Acquisition Anticoagulant Multiple concentrations evaluatedNoneSodium fluorideBiospecimen Aliquots and Components Biospecimen components Hemolyzed bloodPlasma containing 64,000 leukocytes and 1 g hemoglobin/LBiospecimen Aliquots and Components Blood and blood products PlasmaWhole bloodStorage Storage duration 0 min1 h12 h2 h24 h3 h30 min4 h48 h5 h6 hStorage Storage temperature 0-4 degrees C20-24 degrees C38 degrees C