Skip to main content

Effect of pH on the stability of kidney injury molecule 1 (KIM-1) and on the accuracy of its measurement in human urine.

Pennemans V, De Winter LM, Faes C, Van Kerkhove E, Reynders C, Rigo JM, Swennen Q, Penders J

Publication: Clin Chim Acta (2010) • Vol 411 • Page 2083-6PMID: 20837000View on PubMed

Purpose

The purpose of this paper was to determine the effects of pH on urinary kidney injury molecule 1 (KIM-1).

Conclusion

While significant decreases in KIM-1 were seen when urine was stored at pH values lower than 6 or higher than 8, the majority of these differences were eliminated when urinary pH was readjusted to 7 prior to measurement. However, a small but significant decline in percent recovery of KIM-1 was seen when specimens were stored at a pH of 4, even when urine was neutralized prior to analysis. The authors conclude that urinary pH has little effect on KIM-1 levels but that the ELISA kit used to measure KIM-1 is pH dependent.

Studies (1)

Purpose

The purpose of this study was to determine the effects of pH on urinary KIM-1. All specimens were stored, within 4 hours of collection, at -80 degrees C for up to 3 weeks prior to analysis.

Summary of Findings

While significant decreases in KIM-1 were seen when urine was stored at pH values lower than 6 or higher than 8, the majority of these differences were eliminated when urinary pH was readjusted to 7 prior to measurement. However, a small but significant decline in percent recovery of KIM-1 was seen when specimens were stored at a pH of 4, even when urine was neutralized prior to analysis. The authors concluded that urinary pH has little effect on KIM-1 levels but that the ELISA kit used to measure KIM-1 is pH dependent.
  • Biospecimens

    FluidUrine
  • Preservation Types

    Frozen
  • Diagnoses

    Normal
    Not specified
  • Platforms

    ProteinELISA
    Electrolyte/MetalpH
  • Pre-analytical Factors

    ClassificationPre-Analytical FactorValue(s)
    PreaquisitionBiomarker level
    Elevated KIM-1 values (2659 pg/mL)
    Normal KIM-1 values (438 pg/mL)
    Biospecimen Aliquots and ComponentspH
    4
    5
    6
    7
    8
    9