The preservation of urine samples for determination of renal stone risk factors.
Nicar MJ, Hsu MC, Johnson T, Pak CY
Purpose
Conclusion
Studies (2)
Purpose
The purpose of this study was to assess the effects of a 5 d pre-processing delay at 4 degrees C compared to case-matched control specimens that were refrigerated at 4 degree C no longer than 24 h prior to processing. Specimen pH was determined prior to processing. Urine processing entailed the following analyte-specific preservation methods: addition of hydrochloric acid to a urine pH of 1.0 followed by refrigeration (calcium, magnesium, phosphorus, oxalate, ammonia, citrate, sulfate), refrigeration (sodium, creatinine), or addition of chloroform followed by refrigeration (uric acid) until analysis. Analysis was conducted within 1-2 weeks of processing.
Summary of Findings
Storage of the specimen for an additional 5 days at 4 degrees C prior to processing only caused a slight increase in specimen pH (6.52 to 6.61, p<0.05). Slight declines in citrate (5.6%) and oxalate (10.5%) were also noted but not significant. No precipitation or bacterial odor was detected in stored specimens.
Biospecimens
FluidUrinePreservation Types
Other PreservativeDiagnoses
Other diagnosesPlatforms
Small moleculepHSmall moleculeClinical chemistry/auto analyzerElectrolyte/MetalClinical chemistry/auto analyzerSmall moleculeColorimetric assaySmall moleculeRadioimmunoassayPre-analytical Factors
Classification Pre-Analytical Factor Value(s) Storage Storage duration 5 dLess than 1 dStorage Storage temperature 4 degrees C
Purpose
The purpose of this study was to assess the combined effect of urine specimen bacterial contamination (inoculation with 1 of 3 strains) and a heating regime (37 degrees C for 1 d, 65 degrees C for 1 d, then room temperature for 1 d) prior to specimen processing on 13 clinical analytes. The effectiveness of 3 chemical preservatives added prior to bacterial inoculation and specimen heating was also evaluated. Controls were untreated case-matched specimens that were stored at 4 degrees C no longer than 24 h prior to processing. Specimen pH was determined prior to processing. Urine processing entailed the following analyte-specific preservation methods: addition of hydrochloric acid to a urine pH of 1.0 followed by refrigeration (calcium, magnesium, phosphorus, oxalate, ammonia, citrate, sulfate), refrigeration (sodium, creatinine), or addition of chloroform followed by refrigeration (uric acid) until analysis. Analysis was conducted within 1-2 weeks of processing.
Summary of Findings
The elevated temperature, increased bacterial load, and increased storage duration resulted in significant decreases in calcium (14%), citrate (37.7%), and creatinine (10.8%) and increases in oxalate (31.4%) ammonia (84%) and pH (3.6%). The addition of thymol to specimens prevented the decrease in citrate and blunted the change in ammonia (21%). The use of thymol with HCl and boric acid caused an expected decline in pH and precipitation of the uric acid. Citrate and cAMP were not measured in acidic specimens due to methodological limitations. The authors conclude that the use of thymol alone is insufficient but in combination with hydrochloric and boric acid it is an acceptable preservation technique.
Biospecimens
FluidUrinePreservation Types
Other PreservativeNone (Fresh)Diagnoses
Other diagnosesPlatforms
Small moleculeRadioimmunoassaySmall moleculepHSmall moleculeClinical chemistry/auto analyzerSmall moleculeColorimetric assayElectrolyte/MetalClinical chemistry/auto analyzerPre-analytical Factors
Classification Pre-Analytical Factor Value(s) Biospecimen Preservation Fixative additive/buffer Boric acidHydrochloric acidNoneBiospecimen Preservation Type of fixation/preservation None (fresh)RefrigerationThymolStorage Storage temperature 37 degrees C4 degrees C65 degrees CRoom temperature